I am buliding a 1.8 eng 96 MM pistons stroker crank etc... but I have a question about the push rods I want to use the rockers from a 1.7L I know I can up to .060 of the back of the rocker and I am not sure what if I have to do anithing w/ the push rods
Please Help!!!
Iván
go to Jake Raby's type4 forum. He has it spelled out quite clearly.
You will want to make custom pushrods in order to get the most out of your cam.
Find the tech article at Raby's site - he does spell it out well. You want chromoly pushrods, not aluminum. You can get them from Raby or through European Motor Works.
Zach
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)