I am buliding a 1.8 eng 96 MM pistons stroker crank etc... but I have a question about the push rods I want to use the rockers from a 1.7L I know I can up to .060 of the back of the rocker and I am not sure what I have to do w/ the push rods
Please Help!!!
Iván
I did find this old thread...
http://www.914world.com/bbs2/index.php?showtopic=98016&st=0
Measuring and cutting aftermarket pushrods after the bottom is assembled is the best way
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)