Anyone know where I can get new ends for the back-up switch wiring?
I think I used male bullet crimp connectors
use a "blue" butt splice connector. crimp one end to the wire and trim back the insulation on the other end. enlarge the end slightly to fit w/ an small nail.
Oh brother... Slits has been drink'n again.
Check w/Perry Joe.
Crimp-on 'BULLET' connectors are what I used too ... and a new boot, to boot
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)