i am finally done with the engine wiring and I am now in the process of putting all new vacuum hose , i got new hose, nice color diagram, I have all the parts but the flash back , do you have a picture can you adapt something, what about the trottl body I got 2 different 1 that has a adjusting screw on the top the other one on the side , which one is right for a 1.7 72, the number of vaccum port are different too ??? any hints
a 914 almost ready to start
The answer is no - send me your address, I'll send you a "flashback" valve. End of story. Pics a little later of the TB.
This is a 1.7 installed on the plenum. Butterfly cam is up and screw can be seen.
Pharting cleans it out so it works correctly!
thanks slits, i have e-mail you my address and thanks for the picture, 1 thiong I noticed is that the tb has a little flit tab to attached the spring, the difference between the two i have is that the other one does not have a tab the spring attache right where the throttle cable goes
thanks again
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)