Let's Get the SHO Started
Come on out to Benson, AZ to enjoy sodas, dogs, and burgers while we bench test the 3.2L SHO that is destined for this Porsche 914.
When: Saturday December 8th, 10:00am - 2:00pm
Where: Benson , AZ (30min East of Tucson)
RSVP: PM me for address, map & cell number
Sounds like fun.
I hope you choose to stick with the side exit exhaust
Hey Gerard,
Not sure what my schedule is yet but I will pencil it in and send you a PM when it gets a little closer.
Jason, sounds good. Look forward to seeing you again.
Where are you on your project? Do you have a contact #?
Damn, all that shit is gonna fit in that car?
Damn! Is that engine/intake 4 feet tall? Good luck with it all...I thought this was in Washington. I must be confused.
T
Cannot make it
Post videos!
Guys, hard to believe this startup event was back in 2012. Damn time flies. Anyhoo, the results were interesting. Did get it running so I'll post the links to some videos.
Here's the http://youtu.be/12JweTAiARo.
SHO https://www.youtube.com/watch?v=QVD8pCSCRCA.
SHO https://www.youtube.com/watch?v=hTKNkAoOC8g.
Also, here's some pics to answer the fit questions. Here's what it looks like installed - from the top.
And from underneath. The oil pan is right in line with the underside of the floor.
These are the mods for the engine & trunk lids. And a new panel will go on to close everything off - nice and neat.
Plenty of details in my thread - see link in signature.
Thanks for watching.
I am not sure how to send a private IM, you will be #2 on the block, got the sho in my 914 quite a while ago and just found you here, 70+ out of second for a 3.0 sho with the mtx trans, send your #, I am curious how you completed the shifter
I am not sure how to send a private IM, you will be #2 on the block, this SHO 914 with the mtx trans rocks , send your #
Fit no problem, just some,minor cutting....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)