The bus guys were using these and said they needed to be a higher temp as they were not holding up as well. Being that the 914 engine compartment is not as enclosed these should fair well on our cars, but if anyone has had any issues please PM me.
Also if anyone wants these at $3.50 a pop let me know I'll extend the GB.
I'll have the production finished by the end of the year
Attached thumbnail(s)
Does this go around the j pipes?
I was looking for a set last week . Put me in for 2 sets
I'll take a set.
I'll take 4.
I'll take a set. Thanks!
I'll take 3 sets Mike. Thanks!
Please add 2 sets to go with the other rubber parts. thanks, mark
I am good for a set. Let me know how to pay? Sure glad the world didn't end
I'm in for a set.
I'm in for 3 sets or 6 grommets, however you want to put it.........could go in with the F & R Fiberglass bumper tops I have coming....LMK.........Jerry
I am in for a set Mark...
Thanks.
Count me in for 2 pair (4 each.) please pm me with details.
Thanks for doing this.
I'll take 2 sets.
I'll take two sets, too.
Two sets please.
Thanks,
Jeff
Just finishing up the run on these this weekend. I'll be PM'ing everyone Monday morning.
-Mark
Well looks like i may need a pair of these to go with the new chicken neck wire harness tube GB
Hey Mark
Can you put me down for 2 sets as well.
I am emailing your assistant re a bunch of bits and pieces for a new order.
Thanks very much.
Paul
Add 4 sets to my other GB order.
Thx
Niklas
Is it possible to get a set with no cutout? I have Headers, and my holes need to be plugged.
I will take a set
One set for me too, please.
-marcus
PM's sent to all who signed up with a littlte bonus for those that committed prior to production.
Thanks
The GB will be open until Feb1st
I'll take 2 pair as well, thanks
PM's sent
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)