is it 2 lines with a coupling so that the lines can run thru gromets at both ends?
my guess is the factory manually flared the ends of each line at this location.
guess a gromet could be sliced to fit over line - duh.
i measured the length from front to back at about 4'8" +-
Attached image(s)
The rear end of the line has crappy curves so it is not
possible to get the line in the tunnel in one piece
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)