Posted by: Type 47 Jan 16 2013, 08:29 PM
I did a quick look and saw AA has tabs for a Weltmeister bar...does that work or is there a more specific tab to use?
Posted by: Eric_Shea Jan 16 2013, 08:58 PM
These...
http://www.pmbperformance.com/catalog/item/1925565/7777973.htm
Posted by: rjames Jan 16 2013, 11:00 PM
Make sure you weld in the plate adapters, too. (also shown in the link that Eric provided)
Posted by: euro911 Jan 16 2013, 11:44 PM
Hey Eric ... have you thought about supplying these?
Posted by: Type 47 Jan 17 2013, 07:34 PM
QUOTE(rjames @ Jan 16 2013, 09:00 PM)
Make sure you weld in the plate adapters, too. (also shown in the link that Eric provided)
All ready got everything else...I was going to swap out the A arms, but decided it would be a lot easier just to do the weld on adaptors.
Ordering them now.
Thanks guys!
Posted by: dfelz Jan 17 2013, 09:05 PM
QUOTE(euro911 @ Jan 16 2013, 09:44 PM)
Hey Eric ... have you thought about supplying these?
Mark, who currently sells those??
Posted by: euro911 Jan 19 2013, 11:05 PM
Mark Bland (Engman) used to make them. Unfortunately, Mark passed away a few months ago.
Posted by: Mikey914 Jan 20 2013, 03:32 AM
I have access to a waterjet, if there is no one making these I'd be happy to pick this up.
Besides, I can use a set too.
Posted by: Type 47 Jan 20 2013, 09:07 AM
QUOTE(euro911 @ Jan 19 2013, 09:05 PM)
Mark Bland (Engman) used to make them. Unfortunately, Mark passed away a few months ago.
OMG, I didn't know that...I bought some other conversion parts from him last spring.
RIP Eng
Posted by: cary Jan 20 2013, 09:14 AM
Mark, I'd take a set if you're going to load the program to cut some.
Posted by: Luke M Jan 20 2013, 09:38 AM
QUOTE(Mikey914 @ Jan 20 2013, 02:32 AM)
I have access to a waterjet, if there is no one making these I'd be happy to pick this up.
Besides, I can use a set too.
I'd be in for 2 sets.. keep us updated...
The next group buy ??
Posted by: euro911 Jan 20 2013, 12:56 PM
I posted a want ad back in December. I'd like a set as well, Mark