I'm in the process of putting together the headlights in my early 72. The lift rod passes into the headlight bucket through a "brush". I think I have them on the right side but am unsure of what hardware was used to secure them. The hole just look like they used sheet metal screws. If so do they point out into the trunk or into the bucket?
Took 1000s of pics and don't have one of this. LOL
Thanks
Ken
[attachmentid=362278]
Attached image(s)
just like that
If you are not going for the original look, you might want to update to the later rubber cover that goes over everything, It does a better job of keeping the moisture out.
just curious, is this a 4 or a 6 ?
It's a 4. Thanks guys. May have a couple question later. Can't believe I never took a pic when disassembling these.
Ken
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)