So, i reading through the rebuild steps in the manual today...
says there should have been clip on torsion bar, mine slid right out when I released and pulled the adjuster.
Should they just slid out?
Mine did, no clips that I saw. Well, one did. The other was all plugged up with dirt and crud, it needed to be coaxed a bit.
One did, one didn't. Had to drill a hole in the front of the torsion tube (I think some of the A-Arms have a removable cap), and use a punch and hammer to get it out. I think I got the information from Wanye's 101 projects book. Used sealant to close the hole and keep future dirt/water out.
-Justin
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)