I made a center cap removal tool!
Attached image(s)
Back view of the fuch w/ center in.....
Attached image(s)
That is a hell of a lot fancier than mine. I just bought some PVC pipe fittings from Home Depot and filed them down till they fit in the hole in the rim. The other one was opened until it fit on the rim of the cap.
Cheap and easy.. Like a lot of the people on this board!
Add the tool with a bolt 3/8-16 x 3
Attached image(s)
tap once
Attached image(s)
tap again and done
Attached image(s)
I found a small spray can (I think an old spray lube can) and it fit perfectly in the ID at the end of the cap.
Tap tap tap and it was out.
Cost... free
I used another Old Beat-up centercap
what are those goodies in the background?
Well , supposed to be an ecomm thingy - 914 CLUB key fobs - made them for the FFC folks. I am on the fence as to make/market them - they required a lot on hand work after they were cut.
M
screw the tool (nice job, btw) i like those key fobs!
Yeah, I like the key fob too. As a collectible! Looks too big to put in my pocket or hang from the ignition switch.
I want a key fob.
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=20348
I just posted a center cap set on the above thread. $6 at Lowes for both pieces.
Attached image(s)
the keyfobs fit nicely in your pocket, not too big at all.
see?
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)