Hi,
I started installing these today:
http://www.elephantracing.com/suspension/mounts/911/914frontmounts.htm
and while I'm not done yet, when I installed the rear set (in the cross bar) they were VERY tight to get in there. Is that right? I see how the instructions say not to torque the bolt to the car until the a-arm is in and all is aligned, and I haven't done that yet, but even just getting the mounts in there (no a-arm) was quite tight.
Is that normal?
-Steve
Photo... On both sides, the shiny gold part is super tight going into the aluminum cross member.
Attached thumbnail(s)
And by "super tight" I mean I needed a hammer. Hammers are good, right?
-Steve
Ah, hadn't seen this:
http://www.914world.com/bbs2/index.php?showtopic=186228&hl=elephant+Control+Arm+Mounts
That's somewhat helpful. I guess it's often tight. Although your cross member looks bent a little so you couldn't fit any washers in there. Mine are in there, just very tight.
I think I will pull them out and grease between them so they can rotate a little easier...
> Is that the 911 front crossmember?
Yes.
-Steve
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)