I want to replace the transmission shift seal. It is leaking a lot of oil. My question is it a torx screw or pressure pin that i need to punch out. Or do i need to remove something else to get to this seal. I dont want to break anything before i start hitting away. Thanks
[/quote]
You need to drain the transmission, remove the 2 bolts and pull the plate / fork out. Once out then you can use a hammer and punch tool to take out the pin. You will need to replace 2 seals in there. AA and pelican sells them. Easy job. Takes about 30 minutes once you drain the fluid.
Here is a picture of the fork out
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)