My car (74) came without the console from the factory and from a member I bought a nice factory one a while back (Thank you).
After the car was sitting for a while now and the engine getting back in next weekend i'd like to put my new gauges and the new old console in.
The gauges are new VDO gauges for Volt, Oil Pressure and Cyl Head Temp...
Of course they are a little smaller the the OE...
What is the best (and hopefully the easiest way) to fix it or fit them?
http://www.pelicanparts.com/cgi-bin/smart/more_info.cgi?pn=VDO-600851&catalog_description=VDO%20Gauge%20Adapter%20Ring%20
I think that is probably what you need.
or
You could just make a new face for the console with smaller holes.
I have also heard of people carving up rolls of electrical tape to go around the gauges so they fit nicely in the rubber holders.
--DD
This may sound haywire,but I just took the original rubber ring and folded it inside-out,slipped it over the new (smaller) vdo and it fit nice,and was easy as can be.
(obviously the temp guage is the new one)
Not bad,and tough to notice.If I was doing all 3,heck, I doubt anyone would notice.
or a short piece of 2" ABS pipe
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)