I currently have a 73 2.0 with the original Fuchs. Can I just bolt these puppies on in their place?
http://www2.cip1.com/ProductDetails.asp?ProductCode=C32-EIC-A
Will this mounting hardward fit too?
http://www2.cip1.com/SearchResults.asp?Search=4X14ACORN
Thanks!
The lug pattern looks good. I'd be worried about the back spacing and width. See this thread for your Fuchs specs: Post #2
http://www.914world.com/bbs2/index.php?showtopic=78677&hl=lug+spacing
those wheels are pretty cool.
They’re EMPI so they’ll bolt on, but it’s pretty safe to say they’re going to be Beetle offset which means anything besides 165R-15 will rub. If you’re serious about running them go to The Samba and ask the Type 3 or Karmann Ghia crowd if they work. They pretty much need the same offset.
These are 3.5" spacing and 914 needs 4.5"
I have seen 914s with those wheels.
They work but the offset will limit your tire selection. Fine for a street car, not great for a AX car.
Zach
... also at that price they're most likely cast rather than forged. They'll likely break instead of bend if used on the track and treated harshly, or you hit a curb at speed. That is unless they're actually steel!
I bought these recently and am very happy with them.
http://www.914world.com/bbs2/index.php?showtopic=202863&hl=wheels
Correct backspace and with new toyo's - look different than the few other street 914's around...
Don't buy the caps, however... very heavy and $$. You could find a set of 911 caps and paint them cheaper!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)