i have a pretty fair set of hes where some dapo trimmed the tops of the hoops. both hes, both hoops on the outside. prob some feeble effort to tighten/seal an exhaust leak up real good. i need the dimension from the top of the hoop to the top of the pipe. as many measurements as i can get so i can determine if the good hoops still workable and the hes are salvageable. ether 2.0 or 1.7/1.8. pictures show the issues. tia.
k
Attached thumbnail(s)
Cast hoops - early cars
Top of down pipe to top of flange = 0.942"
Flange thickness = 0.904"
Top of down pipe to bottom of flange = 1.922"
Welded hoops - later cars
Top of down pipe to top of flange = 1.034"
Flange thickness = 0.903"
Top of down pipe to bottom of flange = 1.962"
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)