Are these for bump steer? other wise where do they go?
2 large washers ~ 3/16" thick that came with the kit??
Why no classic thread on this subject? Guess i'll take some pictures as I go on this stuff
They go on the end of the tie rod where it screws into the rack.
BTDT
BTDT - they go on the rack/tierod , they kepp you from over turning the steering rack
Hey Will,
Which tie rod kit did you get?
You'd do a great many of us a great service if you could document the entire process. I'd buy you a beer or two
They look like this?
If so, they go in between the rack and the body.
EDIT: sorry, maybe not. I was thinking about the bump steer kit. If they came w/the tie rods, they probably go on the tie rods:
http://weltmeister.com/productslist.aspx?CategoryID=31&selection=7
-Bryan
Ok, over turn washers make sense
This will all be part on progress thread. I would love to contribute a piece for the team.
Tie rods is one.
Drilling for swaybar is one too!
BTW - have bump steer kit on order too. (only item that has not come)
Mine went in the "big effin' washer " storage bin.
They are to keep the threaded end of the tierod from bottoming out in the rack. Apparently some need them & some don't.
Good to see we have consensus on this.
I'll let you know if I figure it out before you all stop arguing.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)