Hi All -
I am getting ready to replace the bushings on my weltmeister sway bar. The bushings I am referring to are the ones that are actually on the bar itself - not the drop links.
I did a bunch of searching but did come up with much.
Has any one done this? Once I remove the three bolts in the wheel well, do the bushings simply slide on and off of the bar? They are a pretty hard material.
Thanks!
Scott S
http://www.914world.com/bbs2/index.php?showtopic=163439
I have a 22mm Welt bar and bought new bushings for it also. I haven't installed them yet. I will say that the larger bar will slide through one side and out the other with semi worn bushings. I highly doubt you need to split them with a large bar. If it's the smaller stock bar then you need to split them.
Custom bronze, after I crushed the first set.
Hi Larry -
I got them from automotion (prepare yourself - unless you are ordering a bumper for a 1996 chevy pickup, their customer service folks are absolutely worthless...)
Here is the part number for the 22mm: PZC-SB-1100D
If anyone should need the 19mm, here is the part number: P9132343
They may tell you that the part numbers sound incorrect. That means they did not actually take the time look it up. Trust me, the numbers are correct. I bought a set of each size just last month just to have them on hand.
If you dont mind - can you update me on how your install goes? I am still nervous about simply opening mine up (previous owner install - no idea how it goes togther....)
Good luck!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)