Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ My 71 turn signal indicators in gauge

Posted by: porsche913b_sp May 18 2013, 11:08 PM

When I use the right or left turn signals the exterior lights operates normally but the indicator on the center gauge flashes 1x or 2x then goes out, what gives, I try looking at the diagram and the wires comes from the #31 warning light switch, what's that ?? Is that a fancy name for the turn signal assy. If not where is this WARNING LIGHT SWITCH ??

Anyone got any ideas. I am sorry I don't even know what to search for on this electrical gremlin.

Thanks in advance
Ted

Posted by: 914itis May 18 2013, 11:12 PM

I posted a thread for this 2 days ago.

If you don't have the bulbs installed on the front or rear signals or the housings are disconnected, you will experience that.

Posted by: porsche913b_sp May 18 2013, 11:19 PM

no I checked all the exterior turn ights and they working fine
blink.gif

Posted by: 914itis May 18 2013, 11:25 PM

Does it work right when you put the hazards lights on?

Posted by: porsche913b_sp May 18 2013, 11:29 PM

I did not try that, sad.gif

Posted by: 914itis May 18 2013, 11:33 PM

I am sure it is something with the load on the bulbs. Are you using LED's? Or any other types of bulbs?

Here is the thread. http://www.914world.com/bbs2/index.php?showtopic=210384&hl=

Posted by: porsche913b_sp May 18 2013, 11:47 PM

Nothing special, original lighting, I will have to re-examine the bulbs more closely and check if the hazard works also,

thanks for the tip

beerchug.gif

Posted by: Eric_Shea May 19 2013, 02:19 PM

Relay. Had the same problem. Separate circuits for dash and body lights. Get a new relay.

Posted by: porsche913b_sp May 19 2013, 03:27 PM

QUOTE(Eric_Shea @ May 19 2013, 01:19 PM) *

Relay. Had the same problem. Separate circuits for dash and body lights. Get a new relay.

All lighting works normal including the hazard lights. Which relay Eric ?

Posted by: porsche913b_sp May 26 2013, 03:27 PM

So I bought a used flasher installed it and it is doing the same thing. I added a second ground to the relay which made no difference. I also inspected all the bulbs and they looked normal. Any other ideas ? Could it be the second relay was bad ? Is there any way to test the relay ? Should I try a new one from eBay ? Anything else to check ?

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)