Anyone know where to get a castellated nut of the end of the 914 axle? Or even the size so that I can call around for one? I messed one up banging on it to get the axle out while doing my 5 lug conversion today.
I would say that changing the rear hubs, bearings, rotors, calipers trailing arms and bushings was more difficult than putting the V8 in my car.
Thanks
Mark
Hi Mark,
There 18mm or 19mm not sure which one.
Stephane
M20 X 1.5 thread
Mark,
I have lots of them if you need one. I am over in Wisconsin. I could mail one out in an envelope.
Brian
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)