I know when I installed my CV's, after my rebuild, I found the torque specs here. Now I can't find about it here or in my Haynes manual. What gives?
I'd like to make sure my axles don't fly off on my way to the WCR.
page 92, 31 ft lbs, threads should also be free of grease as well
You did use the proper Schnorr washers as well, didn't you?
31 ft.lbs...got it thanks!
Yes Schnoor washers in place! Just want to re-torque before the long drive.
Thanks fellas!
Hey
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)