I have been cleaning up my parts for my new 2056 install. I was painting the timing marks on the impeller and I noted that there seems to be a part missing on the front of the impeller. Is there not some sort of cone that snaps into the front of the impeller or am I just way off base? If there is a part, anyone know where to get one?
Hey Mike,
I just saw this the other day while scanning the PET:
http://www.porsche.com/all/media/pdf/originalparts/en/E_914_KATALOG.pdf
Page 58 shows a little cone that's supposed to go there. I've never seen an engine with one still intact, but BusDepot might have them. P/N 021 119 149
Nothing else goes there....but be sure to remove the paint where your lock washers seat to maintain the torque on the attachment bolts....
It's a cone, plastic.
Vw or porsche should have one, or the usual aftermarket vendors.
Rich
Yeah, there's a cone. But you'll notice ZERO difference, and you can't see it in the car. Don't bother.
Thanks. Good points from all. I will be sure to do the clean up of the washer area. I was more concerned with function than form in this area. Thanks Mark for confirming that it has little function. But it is always better to ask.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)