Does anyone have any photos or diagrams of how the L-jet Fuel Inj harness is supposed to lay or route through the engine bay?
I Just put everything back together and some of the drop seem kind of tight and i am assuming I haven't laid it back in the same path it was. I have all the connector in the right place just some are a bit tight.
http://www.pelicanparts.com/914/Parts/Fuel/fuel_harness_early_small.htm
Pelican Parts has a few diagrams, above is the electrical wiring for an early 914 fuel harness. Hope this helps.
No layout diagram exists. Its pretty simple - routes between the ECU mount by the battey to where the other end connects at the relay board. Lays over and at the back of the engine bay. Nothing should be tight, if so, readjust to give slack to each branch and connection.
.....Allow(slack in wires) for the vibration of the motor
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)