I am installing all my shift shafts on my 75 side shift tranny. The conical set screws face down, I got that.
But where should the stick shift be when you couple the shaft to the bottom of the stick?
The shaft has very small splines on it, so it can rotate some prior to coupling.
Should I find a gear on the shift console then match that gear as i couple the shaft to the stick? Or does it matter, am I over thinking this?
Clark
Clark it is kind of a Zen thing at best. Took me a lot if adjusting to get it right. I am installing a short shifter and I almost don't want to change it because it is shifting so well.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)