I need to post a WTB for a couple of random small parts so I can get my clutch cable connected to the throwout bearing lever. I know I need the threaded bracket that attaches the cable to the lever. I also know I need the M10 bolt and a washer to secure the wheel/guide that the cable rides on. Is there anything else, any other brackets, etc, not shown in the pic below that I need? I cannot tell exactly what I need from PET and I just want to make sure I ask for the right stuff.
TIA
You need one of these and two jam nuts.
They are a unique size, possibly M7-1.0
Yeah, I just looked in PET again and the clevis has a 911 part number. Pelican has that part in stock. I'll double check my hardware stash for the nuts. Thanks again
Try to locate a metal trunnion block, not the plastic one (shown above).
The nutz are an off the shelf item at OSH Hardware. I don't remember exactly what size, but they take an 11mm wrench.
You may also need a flat washer or two, and a 1" ~ 1.5" spacer between the arm and the double nutz.
You also need the tab washer that locks the cable to the cable stop (before the pulley. Pelican also sells these.
Does anyone have a picture of all of this stuff in place? I'm sure it would make more sense than what I am seeing in PET.
Here's a Pic from Bob's thread, and a couple he sent me to show the banjo clip
part #:
911-423-205-03-M260
At pelican.
Stu
Any one know the P/N of that special washer in the last two photos. I can't find it in the PET and I lost mine
Edit - found it. 914-423-283-00 and pelican only has one left
Thanks
David
yep, 914-423-283-00-OEM. They had (2) when I ordered mine this morning.
as an FYI, the sleeve/boot at the pulley is 914-423-922-02-M260
Thanks again for the pics and info. This was pretty helpful.
I don't think the PET diagram shows this, but in some applications, a spacer may be needed between the trunnion block and the two nuts (as mentioned earlier). This is even with brand new cables on two of my cars
I run the cable as follows:
Through the arm - trunnion block - flat washer - 1.25" spacer - flat washer - nut 1 & nut 2.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)