Where on this blasted car can I pick off another nut to replace the one that just got stripped?? I'm not in the mood to go find one as some store. I believe it's a 11mm.
I believe the clutch cable also uses 7mm nuts (11mm wrench). Borrow 1 from there for today (only today!). But how did you strip that nut? Only needs 10 ft lb torque. Dont retighten before putting the valve cover back on - your valve adjustment will go away.
I just don't know my own strength I guess
the nuts didnt strip on me....i stripped the studs
That's 100x worse.
Ok. I got one that is 100x worse. It happened...to a friend.
Got the P&C's back on, valves adjusted, going for the engine tin....hmmm...where is that pesky little CHT that used to be on #3???
AAAHHHHHHHHHHHH!!!!!!!!!!!!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)