OK the CV joints are NLA, how about what is everyone using for boots after cleaning and rebuilding?
Thank you in advance
The boots are widely available. Lobro still makes them I believe.
Make sure you get the right washers and stick them on the right way.
As far as rebuilding....as far as I know.... once a bearing is gone....it is gone.
I used new Type I's.
Chris Foley at Tangerine machines recesses in them for the gaskets.
Good luck.
Thank You for the tip.
if you can find an old original set of 2 piece boots. (picture) ones that the flange seperates from the boot, than i recommend rockford driveline boots. they are way thicker and made of better rubber than the new german or brazilian boots. i got sick of replacing boots every 5k miles. the rockfords are well over 10k now and feel brand new.
http://s722.photobucket.com/user/mrbubblehead_photos/media/NCM_0007_zps84817080.jpg.html
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)