I am in need of some new wires.
I have at least two sets of older plug wires and most of the ends look OK.
It is the wire that gets old, nasty, contaminated, etc.
Cant I just buy some new wire and transfer the ends?
If so, what is a good size & a decent brand?
Anyone want to go in on a roll?
Any suggested vendors, or "Just call Chris @ Tangerine?"
I have a set of Chris' wires and they are quite nice, but like you I've threatened to do this for years. MSD and a few others sell them in bulk through the normal avenues; JEGS, Summit, etc...
the type of wire depends upon your ignition.
But yes, you can buy a roll of it from summit etc...as stated above.
I don't have a msd yet but I plan on upgrading soon. Can I just get the fancy spiral wound stuff now even though I have stock ign.?
I'm not 100% sure but I think that direction is fine, it's if you have a Mallory setup that you need the special wire.
McMark already has it in bulk. Magnecor I believe. The plug wires on the engine I just sold were made by him. He can probably make you a set or sell you what you need to make your own.
You can buy bulk wire, ends, crimper from Napa also.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)