Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ trying to find post about wiring fuel pump to old fi relay
Posted by: rosenfe Nov 11 2013, 05:05 PM
i did see a post where upon removal of carbs a red wire was used fro fi relay to new pump for carbs,can anyone direct me to it?ive searched but cant find it
Posted by: rosenfe Nov 11 2013, 05:06 PM
i did see a post where upon removal of carbs a red wire was used fro fi relay to new pump for carbs,can anyone direct me to it?ive searched but cant find it
i meant upon removal of fi
Posted by: jimkelly Nov 11 2013, 05:10 PM
http://www.914world.com/bbs2/index.php?showtopic=25954
the wires to your old pump would be used, in addition top the jump at the relay board.
Posted by: Harpo Nov 11 2013, 05:31 PM
There are photos to show this but until someone posts one I will try to verbally describe it. You will need a jumper from ground to one one the exposed terminals that the FI harness was plugged in to. I believe it is out board drivers side closest to the driver. Hope that makes sense
I will try to get a photo once I get home
David
Posted by: rosenfe Nov 11 2013, 05:36 PM
There are photos to show this but until someone posts one I will try to verbally describe it. You will need a jumper from ground to one one the exposed terminals that the FI harness was plugged in to
I will try to get a photo once I get home
David
thats the post i wanted,thanks
Posted by: SirAndy Nov 11 2013, 06:49 PM
There is a cleaned up version of that post in the tech articles:
http://www.914world.com/specs/SirAndyCarbFuelPumpRelay.php
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)