I need the brake line for the left rear caliper that goes from the factory rubber line (now stainless) to the caliper. I don't see it on PP's website. AA's site says they have it for $20.00 plus shipping and who knows if they even have it. Any suggestions?
Thanks,
Mike
Hi Mike.
You can make your own. Go to your local auto parts store, get a replacement steel line and a cheap line bender tool.
You need the tool. Simply bending the tube in your hands will cause it to crease.
-Rusty
Hey Rusty, thanks for the advice. How about the nuts? Will the tool flare the ends properly and are the nuts available? One nut is OK from the original line but the other is seriously fubared!
They come with the correct fittings and flare.. all you have to do is bend it.
I use a paint spray can (Krylon style) to get the proper bend for the rear lines (bend it around the can)
You dont have to worry about the flare and the fittings. Just buy the proper length.
B
Thanks Brad & Rusty!
You can go to AutoZone and borrow the bending tool and flair kit from them, they are both part of their tool loaning program. You pay for it, return it, and get ALL your money back.
Did the AutoZone thing. Worked great. Installed the new line with no problems.
Thanks,
Mike
Wait.. you mean.. something we told a "club member" actually worked ???LOL
Good job Mike.
B
What are the appropriate lengths, or can I get close enough by just running a tape measure along the old lines?
Thanks
Run a tape measure down the old lines. Or do like I do... and cut a piece of string and take it with you to the parts store.
B
Hey, that's my trick!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)