I have been making these as a composite. And the only other option is a foam seal that really didn't fit well. So I got off my a$$ and improved these.
The problem has allways been that the water can get into the lens easily. Now I made a lip that contours to the inside of the lens gasket. I made this from neoprene at 40 duro so it's nice and supple. I'm really happy with how this came out. I will a product ready to ship in 2 weeks. Who want's these?
Attached thumbnail(s)
the profile
You can se ethe relief for the edge of the lens follows the lens. Novel idea huh?
Attached image(s)
It's even tight enough the friction fit holds the lens
Attached thumbnail(s)
Nice!. The old 2 piece foam setup you were offering...er...Sucked!
It was better than the foam ring that never actually sealed anything. But, yes, there is a better answer. Just took me a bit to get back to it.
In for a set
I'll take 2 sets
I'll take TWO sets please
I'm in for 1 set
I am in. I have the old type on and they were far better than what I had or could find at a reasonable cost anywhere. But these look like just the thing we need.
How is it that Mark winds up with so much of my money?
2 sets here, and thx for the continued development of a product.
I am in for a set!
In for 1 set.
One set.
I'll have a set along with the FI plug seals
i am in for one set also.
one set please
add 1 set to my wing window seal order
Thanks
Dave
Mikey914, are these available yet?
add me in for a set also
I need a set too.....
One set for me.
Please count me in for a set as well, thanks!
one set
PM's sent to all
Thx
Mark,
One set please. Can be sent with sun visors
Thanks
David
If these are still on I will take a set Mark.
Thanks
Mark, I'll take two sets,tell me when to send paypal. John
No problem,
I actually set these up on the site so that they can be bundled with outer group buys and if you need anything else you can get it too. It saves me trying to invoice everything manually, or my guys from guessing what the paypal was for that just hit.
http://shop.914rubber.com/GB-Specials_c22.htm;jsessionid=18C0BE9729217ACF29740DFE117BEAF4.m1plqscsfapp05
I did open up a few other older GBs to make it worth the shipping.
Mark
I'll take a pair...
Does it realy cost $6.80 to put these in an envelope and mail them?
Yeah, just order more rubber stuff and make the postage count, Jeff
Mark is the busiest man alive! I wish I was half as motivated! Cool new product! It took me a few cars worth of parts to find a nice stock pair. Nice!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)