Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Rusty jack points

Posted by: Shindog1961 Feb 17 2014, 12:35 AM

Found this roller locally. Here are a couple of pictures, the majority of the rust is at the jack points. How bad does it look?

Attached Image

Posted by: Shindog1961 Feb 17 2014, 12:36 AM

more picsAttached Image

Posted by: Shindog1961 Feb 17 2014, 12:37 AM

Rear trunk

Attached Image

Posted by: Shindog1961 Feb 17 2014, 12:38 AM

Front

Attached Image

Posted by: Shindog1961 Feb 17 2014, 12:40 AM

Interior

Attached Image

Posted by: cary Feb 17 2014, 08:31 AM

Looks like your car is upside down ...................

On a serious note. Looking at the front trunk seal railing, looks pretty solid. But the jack points, not so much. You need to keep digging. It would be best to get it on a lift to look at the bottom.
From what I see and have seen. That's just caused by not taking off the outer rocker and cleaning out the dirt and debri. It's just a matter of how much the inner rocker and the bottom of the wheelhouse have been compromised under the jack point

I'll let the experts chime in. But I think you'll find the same thing on about 75-80% of the cars you'll look at that haven't been loved for a while.

Posted by: rick 918-S Feb 17 2014, 08:48 AM

Is that the left side jack point? It's a full on structural repair from the looks of that photo. But if there isn't rust at the cowl or lower front fenders it may be a good candidate for repair.

Posted by: Shindog1961 Feb 17 2014, 12:35 PM

Yep thats the drivers side. Here's a photo of directly underneath

Attached Image

Posted by: SirAndy Feb 17 2014, 04:01 PM

Too close, you need to back off and give us the bigger picture.

What does the hell hole look like?
idea.gif

Posted by: euro911 Feb 17 2014, 04:52 PM

Looks like you're going to need to go a little further fore and aft and get down to the bare metal to see the full extent. I think you're looking at repairing some of the long(s) in addition to replacing the jack point components ...

Posted by: Shindog1961 Feb 19 2014, 12:49 AM

Hell hole not bad, just the tray is rusted. Beyond what is in the picture, its solid.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)