I haven't installed a windshield in a 914 since my first one in 1987 and we didn't use the factory rubber spacers.
Well, it's time to put a windshield in 914RS and I ordered those two little rubber spacers from PP, but I don't know where they go.
Any pictures or good descriptions?
From my understanding & watching, they are only to provide the spacing from the bottom of the cowl. They are for locating the position of the glass only and do not remain on the car.
But then, this could be bad advice.....
They don't stay on the car? Damn, I could have used chop sticks. $2 down the drain.
QUOTE (914RS @ Jan 6 2005, 05:01 PM) |
They don't stay on the car? Damn, I could have used chop sticks. $2 down the drain. |
As long as they don't interfer with the trim, no harm leaving them in place. I always leave them in if I can.
Andy, Butyl has no H.
QUOTE (McMark @ Jan 6 2005, 07:55 PM) |
Andy, Butyl has no H. |
QUOTE |
Andy, Butyl has no H. |
QUOTE (aircooledboy @ Jan 6 2005, 07:12 PM) |
As long as they don't interfer with the trim, no harm leaving them in place. I always leave them in if I can. |
QUOTE (9146986 @ Jan 6 2005, 10:10 PM) |
.... especially if the car really won't see rain. |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)