I am sending my mount bar up to Ricks so he can mod it. I had a run in with the FedEx guy over the last stuff I shipped. Lets see him bitch about this. Its a 4 inch ID PVC tube and the bar is wrapped in foam rubber. The ends are screwed on covered in duct tape then the FedEx spec mylar tape. Here is a test for all the sharp eyes in the bunch. Whats wrong with the back seat in my Jetta? No prize just seeing if you catch it.
Attached image(s)
no seatbelt on the drivers side?
David
Is the drivers side seat bottom a touch too far forward?
NO and No. You are cold, need to look higher
Oh, I see it.. They used italian leather on the headrest, and german leather on the seats!
Seriously though, I'm stumped.
Head restraint on backwards?
The back seat headrest on the drivers side is on backwards!
QUOTE (jim912928 @ Jan 8 2005, 04:08 PM) |
The back seat headrest on the drivers side is on backwards! |
Sumthum wrong with the upper door seal. Either no paint, rust or the rubber is stuck to it. Looks like water drops too.
USPS will not allow ducktape.... i hope fedex does
QUOTE (914GT @ Jan 8 2005, 06:07 PM) |
Head restraint on backwards? |
QUOTE (Aaron Cox @ Jan 8 2005, 06:12 PM) |
USPS will not allow ducktape.... i hope fedex does |
Cool, Just picked up the welder today. I'll be watching for the engine bar.
Pam and Lawrence sent us a possible lead for a shop we may be able to use in Des Moine. I'm going to call there on monday. Things are coming together.
QUOTE (rick 918-S @ Jan 8 2005, 08:46 PM) |
Pam and Lawrence sent us a possible lead for a shop we may be able to use in Des Moine. I'm going to call there on monday. Things are coming together. |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)