I am curious if anyone has found 90 degree spark plug boots that fit onto the plugs with carbs and the CFR throttle linkage.
When the wires come straight up, out of the shrouds they have to bend and rest against the bottom of the carbs.
I am guessing there is some leakage of the spark with the wires rubbing like that.
Any ideas?
I'm guessing you have 2 liter Porsche heads. You could use 911 plug connectors. A little pricey, and your wires may be too short, but wires can be made up from bulk. You'll have to buy the early type, and they require the nuts on the end of the plugs, but they should work well and give you bragging rights (and maybe double the HP, depending on how much you spend on them!). BTW, there are some early Volvo plug wire ends that would work. They used them on the front cylinder. I don't know whether you can buy them separately.
The Cap'n
do you have all of the wire clips/retainers in place? cb tall manifolds or shorties?
Attached thumbnail(s)
The 911 wires look like they would work, but maybe still a little tall...
Here is my issue:
So the 90 degree boots for the rear two cyls only need to stick down about 1-1/2 inches from the engine tins
I was thinking some thing like the K.90 LT1 for the rear two and try the 'Bends to Fit for the fronts:
Any body tried the bends to fit from MSD?
if you install the clips/holders i asked about you can usually steer the wires away from troublesome situations and keep the wires OFF of the tin. esp evident in your second picture. then the holes are plugged too. are there any particular reasons you mounted the cable linkage on the rear of the carbs and the coil way back on the tin?
To the Cap'n just got to ask, I would like to know more about the 911 plug wires and connectors as to the "maybe double the HP",, are you kidding or is a posable increase in HP to a large degree? Just sounds to easy.
Stu,
I redesigned the cable mounts late last year.
Improved plug wire clearance was one of the primary motivations.
This topic in the Member Vendor Forum covers more of the details.
http://www.914world.com/bbs2/index.php?showtopic=224048
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)