Part #8 in the enclosed diagram. Yes I know we normally don't need this part and I'd rather not get into a long winded explanation for why I need it. It's NLA almost everywhere and instead of making the part I though I'd check to see if any of our friendly vendors might have some old stock laying around...
Have you called the dealer?
Here is a source for a hardened 14 mm washer.
https://www.belmetric.com/wfhv14-hardened-flat-washer-p-3732.html?cPath=4_664
It does not give the thickness. If the washer is too thick it will not allow the nut to have full thread contact. That special nut for the pivot shaft must have full contact.
Not trying to argue the need but I have yet to find one a
Or a car. A washer will keep the nut from scratching the paint on the suspension ear.
I checked with local dealers today with no luck, NLA all over the place.
Perhaps the link previously noted will yield what I need....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)