I ordered new spark plugs from Pelican Parts for my 1974 1.8. They are Bosch 7998, like this:
I also ordered new spark plug wires from a generic auto parts supplier...Bosch 09171. When the wires arrived, I discovered that the plugs didn't match up with them. The socket in the wire is too small.
Then I went out to my car and tried the wires and they plugged in just fine. I pulled out one of the current spark plugs and the top of it looks like this:
So that's why I'm confused. Did I get the wrong wires? If so, apparently that means the previous owner got the wrong wires as well, and unscrewed the little top piece from the spark plugs to make them work...
What wires or plugs do I need?
That piece unthreads from the new plug, just use a small pair of pliers to take it off.
the tops of the plugs unscrew
So they're supposed to be like that? I wasn't sure if I got the wrong wires, or if I'm supposed to unscrew the piece from the top of the plug.
I ordered these: http://www.autopartswarehouse.com/sku/Porsche/914/Bosch/Spark_Plug_Wire/1974/Base/4_Cyl_1-dot-8L/W0133-1626139.html
But I appear to have gotten these: http://www.autopartswarehouse.com/sku/Porsche/914/Bosch/Spark_Plug_Wire/1974/Base/4_Cyl_1-dot-8L/BS09171.html
Both of which say they fit the 1.8L 914. I looked up the 09171 wires on Amazon and their car model matching thing said it did NOT fit the 1.8.
So much confusion!
Bosch spark plug wires are crap, that's why Porsche, VW/Audi, BMW, and Mercedes don't use them. Our favorite suppliers can get you good Beru (OE for Porsche) wires, and probably for less money. Give GPR a call. Those big time all-over-the-web parts guys are the LAST place you should be shopping for parts for your 914.
The Cap'n
I bought the Clewett wires from PP. A bit expensive, but they are going to last me for a long, long, long time. Fit and finish was perfect.
the last time I put plugs and Beru wires on a car, I removed the caps from the plugs, I gapped them, then threw the caps away. I then put the wires on, inserted the plugs, and to my surprise the wires wouldn't fit. I then found a package in the wires box with 6 gold caps. Further inspection revealed these wires had normal ends. Anyone else experience this?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)