Hi all,
Just put in new pads. I noticed the retainers had separated at the rivet so got a new set of those.
Just turning by hand and I hear some scraping. It seems to be the rivet making contact with outer edge of rotor.
I think there is only one way these go on but here are some pics in case. Note pin is not pressed all the way in here as I was checking things after I heard scraping.
Thanks
Mike
Doh! Just figured it out. Outer pad down too far. Pin not going through hole but sitting above it.
Neither pin looks seated.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)