I am not able to located a couple plastic bits for my projects.
First does any one know if these parts are still available?
Second, If NLA can 914 Rubber step in and make them...
First up is the rubber deck hinge stoppers for the engine cover. Mine and all that I have found are cracked and all busted up. (see photos)
With out them the lid hits the targa bar at fully open.
Next up is these little caps found on the interior and under the rear targa bar. I have found a few different styles of basically the same cap. Some have no grain, and there seems to be two different sizes. The one for under the targa bar need to be the smaller size. (See photos) Both my projects have these caps missing.
Seems these pesky caps seem to fall off the interior easily and it would be nice to have a bunch of spares !
Thanks !
Attached image(s)
my goof...
I have always found nice ones on the outside of the car under the spare tire/front trunk. They are the same and if your lucky there are two.
No help on the rubber stoppers.
For the plastic caps - take a trip to Lowes. I found some there that fit the openings in the targa pad perfectly and look great too!
The number comes up with this vendor-
http://www.aasesales.com/products/h4d-101464
Thanks for all the leads !!
I have a pair of those in hand, and they don't even remotely resemble what you want. They actually screw in for height adjustment, and are used on the front and rear hoods of 911s. Note the helical groove.
The Cap'n
Most on line VW parts places have the rubber adjust stops for under $2 new.
At the last car show / swap meet Sierra Madre was giving away those stops for free. I think I grabbed two. They advertise on this board.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)