Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Spark Plug Wires for 12mm Spark Plugs
Posted by: Highland May 31 2014, 07:23 PM
I had my 2.0 heads rebuilt for 12mm spark plugs but don't know where to buy ignition wires. I am using a stock distributer.
Recommendations would be appreciated.
Posted by: lonewolfe May 31 2014, 07:31 PM
I had my 2.0 heads rebuilt for 12mm spark plugs but don't know where to buy ignition wires. I am using a stock distributer.
Recommendations would be appreciated.
The spark plug wires should be the same.
Posted by: Vacca Rabite May 31 2014, 08:01 PM
If using a stock dizzy, use stock wires.
IMO no need to use special wires unless you are using some sort of optical dizzy that needs the spiral wound wires.
Zach
Posted by: McMark May 31 2014, 08:23 PM
Stock wires will work fine. If you want tight fitting boots, you can get wire ends from NGK in various angles. They just screw onto the wires (just like stock ends). You can even move the rubber washer/boots over to those ends, just like stock.
More details http://www.ngksparkplugs.com/docs/resistor_covers.pdf.
Posted by: boxsterfan May 31 2014, 09:29 PM
I had my 2.0 heads rebuilt for 12mm spark plugs but don't know where to buy ignition wires. I am using a stock distributer.
Recommendations would be appreciated.
I bought the Clewett wires from PP. About $86 I think.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)