Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ I need a carb fuel pump, with threaded ends

Posted by: brant May 31 2014, 10:13 PM

I have a holley and carter big vane style pump already
but I'm looking for a small in line, similar to carter or pierberg low pressure pumps

I really must have one with threaded ends rather than slip on clamp style barbed connectors...

I would also love something self regulated in the 4-5 psi range....

does anyone have any leads on an in-line rotary with threaded ends

thanks in advance
brant

Posted by: Mikey914 May 31 2014, 11:49 PM

napa $56

Posted by: brant Jun 1 2014, 06:49 AM

QUOTE(Mikey914 @ May 31 2014, 11:49 PM)

napa $56

Which one? I only found a solenoid facet from them. Any chance you have a model?

Thankyou in advace

Posted by: zambezi Jun 1 2014, 11:50 AM

I have used this one before
http://www.ebay.com/itm/AIRTEX-E8902-6-VOLT-LOW-PRESSURE-FUEL-PUMP-OR-PRIMER-PUMP-2-5-4psi-30gph-/230888121418?_trksid=p2054897.l4275
Jim

Posted by: stugray Jun 1 2014, 03:36 PM

Brant,

I have two of something that would work, but do not have threaded fittings.
You could have a look if you stop by for the gas tank holddown

Posted by: brant Jun 1 2014, 04:43 PM

Stu. Very great up.

Out of town still until tomorrow. I think I came up with a pump but thankyou.

I'll email when I get back. I'll buy that tank hold down thankyou!