I am trying to get the 75 up to speed so I can get it inspected. I noticed the horn pad was not setting right so I went ahead and ordered the horn cuff. Well this morning I went out to put it in. Sure enough the old one had collapsed. Put the new one on and the horn pad was still off. I double checked everything , the scratched my head. Got another horn pad and it did the same thing. The steering wheel hub did not look right, It took a comparison of the horn pad and the steering wheel hub to figure it out.
DAPO's ????
Attached image(s)
Yikes! Time to check the engine/ tranny bolts, suspension and other steering bolts.
The tab has not been filed off. That's normal. Which way are you putting the the horn on. Left to right or right to left?
After the pictures of the wheels from Ole Yella, I went back to the garage and started over. The tabs on the hub are all bent up as shown in the pictures. It took 5 hubs until I found one that would work.
Attached image(s)
Missing circlip on shaft causing all things to be tightened too far down?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)