Both my sill covers have small crack from the underside and about an inch upwards about 10-12 inches in from the rear end, since both mine are cracked in the exakt same place I'm wondering if this is a common issue?
I'm going to drill a hole at the end of the crack and then weld them back up. Will probably weld up the jack holes to achieve a smooth look on the sill covers while I'm at it.
Carefully check your longitudinals under the rocker panels to be sure they're not rusting.
Can you post a picture? I don't recall ever seeing a crack there ...
http://matsgarage.com/wp-content/uploads/2014/07/DSC00800.jpg
http://matsgarage.com/wp-content/uploads/2014/07/DSC00801.jpg
http://matsgarage.com/wp-content/uploads/2014/07/DSC00802.jpg
Standard vibrational cracking of rocker panels. They crack where the long ends.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)