I am starting this post as not all of you follow the copious Bus thread (link in my sig below).
I have been developing a CIS based system for the 3.1L corvair engine in it. It worked well enough to do a large circle route around Lake Ontario....but then it started messing up and has sat for months now. I am moving and dont want to tow it and would love to use it to actually haul stuff (shocker). So, it is time to switch to dependable and easier - Webber 3C or Zenith carbs.
What I need is a set of carbs big enough to feed a 3.1 with mild cams, and the manifolds as I do not have any of this. I am not looking to buy as I am trying to same my $$$ to prove I have enough to the mortgage people to secure my loan. However, if I have to buy I have to buy and I will make do. But, I thought I would as here first. I can trade labor
Thanks for your consideration.
Oh ya, I am partially carb stupid so recommendations for size, or other important parameters is welcome
If I were to buy a set, if it comes to that, what size would I be looking for? I see some Zenith cores and NOS ones on ebay. No idea if they would work. Also, dont the Weber and Zeniths use different manifolds? I would hate to go back to the 4bbl Holley as I sold all of my major pieces. I do have a special manifold to fit the heads.....
Starr Cooke is the man for corvair carbs. He sells on eBay and you can probably google him as well. He might be a good resource to see what options you have.
I think it might be easier for you to get someone to give you a 911 six cylinder motor and put in something people actually understand.....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)