hi
as per the images below.
is there supposed to be a Y fitting where the "blue" is?
not sure how to attach the vac line from the decel valve.
the diagram came with the vacuum line kit
thank you
randal
I think that line goes to a nipple on the throttle body or plenum near the throttle body.
No y between the plenum and aar. That line drawn should continue on at the arr
The hose coming off the front of the decel valve should connect to the plenum. You need to get one of those "F" vacuum elbows.
Part # 022129637B
This is what it looks like. I'm sure you can find it somewhere else for cheaper.
http://www.autoatlanta.com/Porsche-Stacked-Vacuum-Elbow-Parts-PN-B022129637B.html
not sure??
image below
A is where E was, and supposedly from the AA diagram that came
with the vacuum lines, D is supposed to go where A is.
B will fit the smaller decell vacuum line, is this correct or do I still need the "F fitting"
what is F and C for
if they had been hooked up when I bought the car I would have images.
any help is appreciated
also where does the decell valve attach?
tks
randal
"B" goes to your MPS.
"C" goes to the rear port of the decel valve
"A" will take the F connector, which will connect to the front port of the decel valve and also to the PCV valve on the oil filler tower
What you have labeled "F" is your intake air temp sensor. There should be a 2-pin electrical connector that plugs into it.
They are just passages to the space inside the plenum. As long as the hose fits, it doesn't matter which one goes where. F is temp sensor 1. It plugs into the wiring harness.
thank you very much, now to get that """"""""F""""""
rubber fitting.
tks
randal
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)