Pumpkin is a 70 1.7, Put on the new back brake disc, new pads, and figured out why back one hung up, piece of metal from old gear for setting vent clearance. got new one (gear) from Eric.
Question is, which order to do what, set vent clearance, bleed brakes, re check vent clearance?
Thanks
Clamp the rotor to the hub with 2 or more lug bolts and spacers as necessary, set the venting clearance to .004", rechecking each side after the other is set. Bleed the brakes rt rear, left rear, right front, left front. Run a minimum of 8 oz. through each caliper.
The Cap'n
Just like you said Set vent clearance, bleed entire system, recheck rear inner and outer clearances
Thanks guys.
Repete at least twice to get all the air out.
Just in time for my new master cylinder tomorrow. Thanks to all.
Set clearance to 4 thou?
i read 8. Could this explain why my pedal was not at the top?
i Think so.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)