I got a oil temp taco plate set up out of a JY car. Wire, sender, cover, plate, clips etc...
I am ready to change my oil and put this thing on. It was probably last summer that I carefully removed it from a 73. I can't remember the path of the wire. There is a connector on my car's harness that is at the battery. I believe that is the connection. And a bunch in the tunnel, maybe one behind the dash. I will check all those.
But from the taco plate to the 1st connector is only semi-obvious.
Pictures would be great, if anyone has them. Hind sight.... take pictures at the JY.
Thanks,
Clark
It comes out of the plate, goes across the front of the engine near the motor mounts (hint: be careful not to squash the wire flat, you get a full-hot reading all the time!) to a stand-off on one of the oil cooler bracket bolts. Then through the engine tin to the connector under the battery that you found.
--DD
In case anyone runs across this post.... I found http://www.914world.com/bbs2/index.php?s=&showtopic=97987&view=findpost&p=1196869
It has helped for sure. pictures too.
Clark
Shoot, that's right! I forgot about that one...
--DD
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)