it doesnt rub, but is very close. is this too close?
Attached thumbnail(s)
another
http://youtu.be/ygCg-qdZvI0
Might rub when the rotor gets hot...then it'll get even hotter! Looks a bit sketchy--where did you source the rotor & caliper??
What is the piston to caliper difference? They should be equal or damn near. You could always machine the caliper.
nevermind... figured it out. struts were powdercoated and i forgot to tape that side off. when i bolted up the other side the disc was perfectly centered.
a little file and sandpaper work and its fixed now.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)