Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ CV bolts- check 'em!
Posted by: rjames Oct 12 2014, 11:40 PM
I know it's been said before, but periodically check to verify those cv bolts are torqued to spec. I think a lot of folks only check the ones at the tranny side, but the ones at the wheel ends of the half shafts should also be checked. I had a couple that were a few foot pounds shy of spec.
Posted by: Hank914 Oct 13 2014, 12:09 AM
I know it's been said before, but periodically check to verify those cv bolts are torqued to spec. I think a lot of folks only check the ones at the tranny side, but the ones at the wheel ends of the half shafts should also be checked. I had a couple that were a few foot pounds shy of spec.
Inquiring minds want to know....
...what is spec for those bolts?
...and what's a good way to estimate torque w/o a torque wrench?
Thanks muchly.
Posted by: bdstone914 Oct 13 2014, 07:04 AM
I know it's been said before, but periodically check to verify those cv bolts are torqued to spec. I think a lot of folks only check the ones at the tranny side, but the ones at the wheel ends of the half shafts should also be checked. I had a couple that were a few foot pounds shy of spec.
Inquiring minds want to know....
...what is spec for those bolts?
...and what's a good way to estimate torque w/o a torque wrench?
Thanks muchly.
32 ft/lbs.
Use a torque wrench. But one, borrow one or many auto parts stores rent them. And use the correct triple square socket you you will strip the head and have a worse problem.
Posted by: 914Sixer Oct 13 2014, 05:17 PM
I checked mine 3 weeks ago and found 2 hanging on by a thread.
Posted by: cary Oct 13 2014, 07:00 PM
I give them a little tap with a ball pine hammer to make sure they're fully seated before I try to turn them with a ratchet.
Posted by: bcheney Oct 13 2014, 07:40 PM
You also need to be tidy when installing CV's...Cleanliness is king, no grease of any kind on the thread surfaces and the tops of the boot plates where the bolts and washers are inserted. I brake clean the threads thoroughly and use new Schor washers everytime.
Posted by: bigkensteele Oct 13 2014, 07:52 PM
Bolts that are pre-drilled for safety wire are available on 914rubber.com. If you really, really want them to stay torqued, that is the way to go.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)