Posted by: mepstein Oct 29 2014, 10:35 AM
What would cause one headlight to cycle up and down until I pull the relay. Just started today.
Posted by: Dave_Darling Oct 29 2014, 11:01 AM
Sticking relay, or bad microswitch in the motor housing.
Swap the relay with the one from the other light. If the behavior follows the relay, you've found your culprit.
--DD
Posted by: 7TPorsh Oct 29 2014, 11:26 AM
Check yer grounds....brown wires
Posted by: 7TPorsh Oct 29 2014, 11:26 AM
Check yer grounds....brown wires
Posted by: sfrenck Oct 29 2014, 12:09 PM
QUOTE(mepstein @ Oct 29 2014, 12:35 PM)
What would cause one headlight to cycle up and down until I pull the relay. Just started today.
Installation of a new / fancy set of LED lamps...
Posted by: mepstein Oct 29 2014, 12:29 PM
QUOTE(sfrenck @ Oct 29 2014, 02:09 PM)
QUOTE(mepstein @ Oct 29 2014, 12:35 PM)
What would cause one headlight to cycle up and down until I pull the relay. Just started today.
Installation of a new / fancy set of LED lamps...
I wasn't supposed to cut any wires?
Posted by: sfrenck Oct 29 2014, 01:37 PM
QUOTE(mepstein @ Oct 29 2014, 02:29 PM)
QUOTE(sfrenck @ Oct 29 2014, 02:09 PM)
QUOTE(mepstein @ Oct 29 2014, 12:35 PM)
What would cause one headlight to cycle up and down until I pull the relay. Just started today.
Installation of a new / fancy set of LED lamps...
I wasn't supposed to cut any wires?
Lucky you didn't cut any fingers...
Posted by: Tom Oct 30 2014, 12:57 PM
I believe a shorted diode will produce that same symptom.
Tom
Posted by: mepstein Oct 30 2014, 03:48 PM
I switched in a new-old relay and it's been working right.